Carbon Fiber 3D black It took me several hours and lots of patience, but I got some very good results. The precision of the vinyl cuts were at times remarkable. Some of the pieces were a breeze to put on. Others required lots of work. These were typically where the surface curves and the flat vinyl needed to be stretched to fit. There were a few remaining pieces that I didn't want to use or didn't know what it went to. My only real complaint is the long L-shaped console trim pieces for my Acura TL. Not only were they surprisingly difficult to get on, the RVinyl didn't totally cover the trim. A 1-2mm band on the inside and a wide 4-5mm band on the outside. The outside would require additional pieces since it's 90 degrees from the main surface. Advice to newbies - don't skimp on the prep! Get a decent micro fiber cloth and clean, clean, clean with the water/alcohol solution. Any residual dirt or oil will make for a frustrating installation with sub-par results.Make: Acura Model: TL Year: 2004